MVI56E-MNETC  Modbus TCP/IP Client Enhanced Communication Module

The Setup Jumper acts as “write protection” for the module’s firmware. In “write protected” mode, the Setup pins are not connected, and the module’s firmware cannot be overwritten. The module is shipped with the Setup jumper OFF. Do not jumper the Setup pins together unless you are directed to do so by ProSoft Technical Support (or you want to update the module firmware).
The following illustration shows the MVI56E-MNETC/MNETCXT jumper configuration with the Setup Jumper OFF.

Make sure your ControlLogix processor and power supply are installed and configured, before installing the MVI56E-MNETC/MNETCXT module. Refer to your Rockwell Automation product documentation for installation instructions.

After you have checked the placement of the jumpers, insert the MVI56EMNETC/MNETCXT into the ControlLogix chassis. Use the same technique recommended by Rockwell Automation to remove and install ControlLogix modules.

The Optional Add-On Instruction performs the following tasks:
 Read/Write Ethernet Configuration Allows the processor to read or write the module IP address, subnet mask, and network gateway IP address.
 Read/Write Module Clock Value
Allows the processor to read and write the module clock settings. The module’s freerunning clock also stores the last time that the Ethernet configuration was changed or the last time the module was restarted or rebooted. The date and time of the last change or restart is displayed on the scrolling LED during module power-up/start-up sequence.

MVI56E-MNETCR