DS200TCQCG1BKG RST Overflow Board GE

The GE RST Overflow Board DS200TCQCG1BKG is populated with 24 jumpers and 3 40-pin connectors. It also has 3 34-pin connectors and 1 16-pin connector. The ID assigned to the 16-pin connector is JC. The IDs assigned to the 40-pin connectors are JFF, JE, and 6PL. The GE RST Overflow Board DS200TCQCG1BKG also is populated with heat sinks that dissipate heat. Consider the following information about the heat sinks before you install and remove the board. The heat sinks protrude from the board and so the board cannot be placed within 3 inches of other boards in the interior of the drive, if the boards are sandwiched together. This is to allow for clearance for the heat sinks and to give the heat sinks the air flow required to dissipate the extra heat. Another consideration is that the heat sinks might damage other boards and components when you arrange the board in the drive. You might accidentally scratch another board or knock delicate components from another board. Also, be careful to avoid scraping the board against other components and knocking off the heat sinks.

The IDs assigned to the jumpers are prefixed with BJ followed by a number. For example, jumpers are assigned IDs BJ1, BJ5, and BJ24. A description of each jumper is contained in the instructions supplied with the board from the factory. And the jumpers are referred to by the jumper ID. When the GE RST Overflow Board DS200TCQCG1BKG is originally installed in the drive the installer moves the jumpers to configure the board to meet the processing needs of the site.