Frequently Asked Questions about DS200FCSAG2A
What is the DS200FCSAG2A?
The DS200FCSAG2A is a Current Sensor Interface Board that uses the abbreviation FCSA in GE documentation.
Is there a parts-specific manual for the DS200FCSAG2A model?
Yes! The parts-specific manual for the DS200FCSAG2A model is the GEI-100222 manual. This manual is not widely available online but information on this board can be found within the GEH-6678G LS2100 Installation and Startup Users Guide attached in the Manuals tab on this page.
The DS200FCSAG2A board can sometimes be found in the Mark V Series from General Electric. How can I be sure that the DS200FCSAG2A can be used with the LS2100 Series?
In the GEI-100476 ControlST Manual, there is a page that detail all of the boards that are in the LS2100 Series. On page two hundred and ninety-three, the DS200FCSAG1A board is listed as boards within the LS2100 Series, along with documentation that can be used when operating and installing the FCSA boards.
How do I check to ensure that the voltage of the FCSA is correct?
To check for the correct voltage verify the voltages at the following points of the LEMPS plug, N15 (pin 3), P15 (pin 1), and ACOM (pin 2), once verified you can reconnect the LEMPS plug at the FCSA-L (load bridge).
Is there a difference between the CPSL and LEMPS connectors on the DS200FCSAG2A board?
The primary difference between the CPSL and LEMPS connectors is the number of pins. Both connectors are used with power control.
What should I do to ensure that there are no power errors when the DS200FCSAG2A board is being used?
If you suspect that there might be power errors on the DS200FCSAG2A board it is best to unplug the LEMPS connector.
1 Year Warranty
