330103-00-07-10-02-00 Bently Nevada 3300 XL 8 mm Probe

Its axial load force with maximum radial load ratings are 18 kilograms (40 pounds) at 5000 RPM, 21 kilograms (46 pounds) at 3500 RPM, 27 kilograms (60 pounds) at 2000 RPM, and 36 kilograms (79 pounds) at 1000 RPM. Its axial load force with zero radial load ratings are 25 kilograms (55 pounds) at 5000 RPM, 30 kilograms (66 pounds) at 3500 RPM, 38 kilograms (84 pounds) at 2000 RPM, and 51 kilograms (112 pounds) at 1000 RPM. To begin mounting the motor, the user is recommended to first provide sufficient clearance and air cooling space along with heat sink mass to ensure that the motor stays within the ideal temperature range of 0 to 40  degrees Celsius (32 to 104  degrees Fahrenheit).  The axial and the radial shaft loads should not exceed the limits mentioned above. The motor is to be positioned such that its connectors point downward. Then, insert the fasteners in the four mounting holes and hand-tighten the fasteners. Verify the correct alignment of the motor on the machine by using the mounting pilot hole, then tighten the fasteners with a torque of 0.8 to 1.0 N-m (7 to 9 pounds on an inch). To verify for electrical phasing of the motor and correct encoder positioning, rotate the shaft. When attaching the Threaded DIN (M4) Cable Plugs, install the O-rings, For the SpeedTec DIN (M7) Cable Plugs, do not install the O-rings An O-ring on the feedback connector is necessary to achieve the maximum environmental rating. Form a drip loop to carry liquids away from the motor connection. Hand-tighten the collar on the plug for proper connection. Do not apply excessive force when connecting the cable plug and the connector. Realign the flat surfaces if the plug and connector do not go together with light hand force.